Congratulations on purchasing your DavidMors watch. Please read these instructions carefully to understand how to operate your DavidMors timepiece.

 

HOW TO START YOUR WATCH

 

To start your watch, remove the plastic guard from under the crown, then press the crown in against the case. The second hand will begin advancing in one-second intervals.

Some deep-depth water-resistant watches require the setting crown to be screwed in to secure water-resistance. If your watch case has a protrusion with screw threads, the crown must be screwed in after setting the watch.

To screw in, push the crown firmly against the threaded protrusion and hold in while turning the crown clockwise. Continue to screw in the crown until it is tight. You will need to unscrew the crown (counter-clockwise) before pulling it out the next time you want to set your watch.

WATER AND SHOCK RESISTANCE

 

All DavidMors watches are water resistant. Please check your watch is compatible with which depth

 

WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS OR PULL OUT THE CROWN UNDER WATER UNLESS YOUR WATCH IS INDICATED AS 200 METER WATER-RESISTANT.

 

  1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
  2. Watch is not a diver watch and should not be used for diving.
  3. Rinse watch with fresh water after exposure to salt water.
  4. Shock-resistance will be indicated on watch face or caseback. Watches are designed to pass ISO test for shock-resistance. However, care should be taken to avoid damaging crystal/lens.

TO SET TIME

 

1) PULL crown all the way out and turn to correct time.

2) Push crown in to restart. For screw-in setting crown, push crown in while turning CLOCKWISE to tighten.

Watches with date: Note correct time of day (A.M or P.M.) for proper date function.

TO SET “QUICKDATE®” FEATURE:

 

3-POSITION CROWN:

1) Pull crown to “Middle” position and turn CLOCKWISE or COUNTERCLOCKWISE until correct date appears.

 

2-POSITION CROWN:

1) Pull crown to “OUT” position and turn CLOCKWISE until date changes. Repeat until correct date appears. Adjust date when month has less than 31 days. Push crown in when finished.

 

Caution: Wearing or storing the watch with the crown in the “middle” position will cause damage to the movement. Always return the crown to the normal position, or if you wish to save the battery life while storing the watch, leave the crown in the “out” position.

 

The date function advances the date between the hours of 10 PM and 2 AM. Avoid setting the date during this timeframe. If you attempt to set the date during this time period, rotate the crown at a very slow rate to avoid damaging the watch.

DAY / DATE MODELS

 

TO SET THE TIME:

1) PULL the crown out to the “C” position.

2) TURN the crown either way to the correct time.

3) PUSH in the crown to the “A” position.

 

TO SET THE DATE:

1) PULL the crown out to the “B” position.

2) TURN the crown either way to the correct date.

3) PUSH in the crown to the “A” position.

BATTERY

DavidMors strongly recommends that a retailer or jeweler replace battery. Battery type is on watch back. If present, push/short internal reset switch after replacing battery. Battery life estimates are based on certain assumptions regarding usage; battery life may vary depending on actual usage.

 

DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP LOOSE BATTERIES AWAY FROM CHILDREN.

 

 

©2017 DavidMors, Inc.